Filter
Top Products
-52- G0501 Sliding Table Saw
Always disconnect
power to the machine
before performing ser-
vice adjustments. Failure
to do this may result in
serious personal injury.
To change the V-belt on the main motor:
1. Move the blade tilt to 0˚ on the control panel
(blade 90˚ to table), and raise the main blade
and scoring blade set up as far as they will
go.
2. Disconnect the saw from the power
source!
3. Open the motor cabinet door.
4. Move the belt tension handle (Figure 90)
down to loosen the V-belt.
Replacing Belts
Figure 90. Belt tension handle.
5. Remove the old V-belt and replace it with a
new belt.
6. Move the belt tension handle up to tighten
the V-belt.
7. Close and secure the motor cabinet door.
This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—it
is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform any
procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
About Service
SECTION 8: SERVICE ADJUSTMENTS