Filter
Top Products
-26- G0501 Sliding Table Saw
Installing Blade
Guard
The blade guard assembly consists of four
pieces: Lower and upper support arms, a pivoting
swing arm and a clear plastic blade guard shield.
To install the blade guard:
1. Remove the six bolts from the side of the
motor cabinet.
2. Position the lower support arm over the holes
on the side of the motor cabinet and secure
it with the bolts and lock washers removed in
step 1, so the assembly looks similar to
Figure 31.
Figure 31. Lower support arm installed.
Figure 33. Pivot bolt.
Figure 32. Vertical support installed.
3. Unthread the eight bolts from the upper sup-
port arm.
4. Position the upper support arm over the
holes in the lower support arm and secure it
with the bolts removed in step 3 (Figure 32).
6. Position the pivoting swing arm over the saw
table (Figure 34) and secure it with four
M10-1.5 x 25 bolts, lock washers and flat
washers. Note—Get assistance holding the
swing arm in place while securing it to the
support.
Pivot Bolt
Pivoting Swing
Arm
Steel Mounting
Brace
5. Loosen the pivot bolt (Figure 33) at the end
of the swing arm to position the steel mount-
ing brace over the end of the upper support
arm.
Lower Support
Arm
Upper
Support Arm