Filter
Top Products
-28- G0501 Sliding Table Saw
Figure 38. Hardware location for small table.
Figure 39. Small extension table installed.
Figure 40. Checking with a straight edge.
4. Use the adjustment screws (Figure 39)
under the extension table to level the top sur-
face with the saw table.
5. When the surfaces are level, slide the table
supports against the machine frame and
secure them with the cap screws.
7. Position the adjustment screws between the
table support braces and extension table to
finely tune the table so it is level.
8. To install the large extension table, move to
the back of the saw and remove the four cap
screws from cast iron table and the four cap
screws from the cabinet.
9. With the help of at least two assistants, install
and level the large extension table in the
same manner as the small extension table,
using the hardware removed in step 8.
Figure 41 shows the large extension table
installed correctly.
3. Position the small extension table over the
holes on the cast iron table and secure it with
the three cap screws that you removed in
step 2 (Figure 39). Note—Get assistance
positioning the table and holding it in place
while installing.
Cap Screws
Adjustment Screws
6. Check the surfaces of the table with a
straight edge a shown in Figure 40.
2. Remove the three cap screws, lock washers
and flat washers from the side of the table
(Figure 38, white arrows) and remove the
two cap screws from the motor cabinet
(Figure 38, black arrows).
Figure 41. Large extension table installed.