Filter
Top Products
G0501 Sliding Table Saw -39-
3000
4000
6000
5000
5. Turn the pulley speed switch (Figure 63) so
that the opening in the fins line up with the
belt position. This switch registers the speed
with the control panel.
Figure 62. Belt speed diagram.
Figure 64. Fence against blade as a guide for
aligning the scoring blade.
Figure 63. Pulley speed switch.
The scoring blade must be aligned with the main
blade to ensure satisfactory cutting results.
Before attempting to align the scoring blade with
the main blade, the kerf thickness must match
that of the main blade.
To align the scoring blade set:
1. Move the blade tilt to 0˚ on the control panel
(blade 90˚ to table), and raise the main blade
and scoring blade set up as far as they will
go.
2. Remove the stop bolt from the rip fence, and
move the rip fence against the main blade (or
scoring blade) as shown in Figure 64.
Aligning Scoring
Blade Set
4. Position the V-belt in one of the pulley loca-
tions illustrated in Figure 62, depending on
your desired blade speed.
Pulley Speed
Switch
6. Move the belt tension handle up to tighten
the V-belt.
7. Close and secure the motor cabinet door.
3. Use the control panel to move the scoring
blade so that the rip fence can touch both the
scoring blade and the main blade when posi-
tioned as shown in Figure 64.
4. Lower the scoring blade to the correct height
and perform a test cut, then make any final
adjustments.