Filter
Top Products
Page 11SKU 96067
For technical questions, please call 1-800-444-3353.
DRILL PRESS SAFETY RULES
1. Avoid unintentional starting. Make sure you are prepared to begin work
before turning on the Drill Press.
2. Do not force the Drill Press. This tool will do the work better and safer at the
speed and capacity for which it was designed.
3. WARNING! Keep hands and fingers safety away from the cutting area.
4. Never leave the Drill Press unattended when it is plugged into an electrical
outlet. Turn off the tool, and unplug it from its electrical outlet before leaving.
5. Make sure the Table of the Drill Press and surrounding area are clear with
the exception of the workpiece to be drilled.
6. Before using the Drill Press, check to make sure the bit is properly
mounted in the Chuck. Make sure the Bit is sharp, and is not cracked or
bent.
7. Never attempt to drill more than one workpiece at a time.
8. Never attempt to drill freehand. Make sure the workpiece to be drilled is
secured in a vise or is clamped to the table.
24. Check all guards for proper operation before each use. Never disable
guards. Do not operate the Table Saw if the guard assembly does not move
freely and close instantly. Before each use, raise the guard assembly and
make sure it moves freely and does not touch the Saw Blade or any other
part, in all angles and depths of cut.
25. Never perform layout, assembly, or setup work on the Table of the Table
Saw when the machine is running.
26. Make sure to remove all adjusting wrenches from the Table Saw before
turning it on.
27. Use a “push stick” or “auxiliary handle” (neither included) only when
ripping widths of 2” to 6”. Use a “push block” and “auxiliary fence” (neither
included) when ripping widths under 2”.
28. Keep the Table of the Table Saw clean and clear of debris. Remove cut-off
pieces and scraps of wood from the Table before starting the Table Saw.