Filter
Top Products
Page 20SKU 96067
For technical questions, please call 1-800-444-3353.
TO MOUNT COLLETS WITH THE DRAWBAR
The Drawbar/R-8 Collet combination is used with all of the tools of the Metal/
Woodworking Machine. To attach R-8 Collets, pass the Drawbar through the Spindle
from the left. Align the keyway in the exterior of the Collet with the Key in the Spindle
and slide the R-8 Collet into the Spindle from the right. Insert the Drawbar into the left
end of the Spindle in the place market “Drawbar.” Turn the Drawbar and thread it into
the Collet until the Collet is tight in the Spindle. (See page 16.)
TO MOVE THE CARRIAGE
The Carriage has three functions:
To adjust the height of the saw Table.
To support the Tool Rest.
To provide left/right and up/down movement for adjustments in horizontal
boring and milling projects.
The height adjustment is geared for the saw Table’s Way Tubes. Pull up on the
Table Lock to tighten it.
Before moving the Carriage to the left or right you must release the Carriage
Lock with a clockwise turn. Then turn the Carriage Travel Hand Wheel in the
opposite way of the direction you want to go.
WARNING! Always check all Locks before operating the Metal/Woodworking
Machine. Always ensure the Carriage and any installed Table or Lathe Tool
Rest are locked down (unless they are being moved). Failure to completely lock
the Table, the Carriage, or the Powerhead can result in personal injury and/or
damage to the Machine. (See page 16.)
1.
a.
b.
c.
2.
3.
4.