Filter
Top Products
Page 29SKU 96067
For technical questions, please call 1-800-444-3353.
Knobs. Failure to do so could cause the Powerhead and/or Carriage to drop
down along the Way Tubes, causing possible personal injury and/or damage to
the machine.
Mount the Drill Chuck by inserting it into the 3/4” Collet. Then tighten the
Drawrod.
IMPORTANT: Never allow the Drill Bit to drop, plunge or cut more than 2” below
the drill Insert hole. There is a Support Bar just under the Table surface.
5.
6.
TO SET UP THE HORIZONTAL BORING TOOL
Insert the Drill Chuck (mounted on its Arbor) into the Quill and tighten the
Drawrod. Then position the Table below the drill center and move the Table and
Carriage toward the Powerhead. (See Figure Q.)
1.
FIGURE Q
FIGURE P