Filter
Top Products
Page 34SKU 96067
For technical questions, please call 1-800-444-3353.
TO ALIGN THE SAW TABLE TO THE SAW BLADE
Set up the machine with the Table in place and the Saw Blade/Arbor installed.
Set the Table Trunnion to zero.
Place the Miter Gauge in the Table Slot closest to the Saw Blade.
Hold a pencil against the face of the Miter Gauge while touching the face of the
Saw Blade. As you rotate the Saw Blade, the high spot on the Blade will push
the pencil away. Mark the high spot with chalk or a felt marker.
Reposition the pencil, the Miter Gauge, and the high spot on the Saw Blade
together at the infeed end of the Table.
Rotate the Saw Blade, and bring the Miter Gauge and the high spot together
at the infeed end of the Table. Make sure to keep the pencil in the same spot
against the Miter Gauge.
The Table is aligned if the pencil tip touches the Saw Blade with the same touch
and in the same place all the way around the Blade. The Table is not aligned
if the Saw Blade pushes the pencil or there is a gap between the pencil tip and
Blade. If the Table is not aligned, loosen all four Capscrews attaching the Table
to the Trunnions. Adjust the Table. Then repeat Steps #2, #3, #4, #5, #6. Once
alignment is achieved, tighten all four Capscrews.
TO ALIGN THE SAW TABLE 90 DEGREES TO THE SAW BLADE
Hold a T-Square on the Table and against the Saw Blade with the high spot 90
degrees from the T-Square. Make sure the T-Square does not touch the Saw
Blade teeth.
If the Table is not 90 degrees to the Saw Blade loosen the front and back
Trunnion Handles.
Move the Table enough so the T-Square’s two edges are ush with both the Table
and Saw Blade.
Use Phillips screwdriver to reset the Trunnion’s 0 Degree Indicator to zero.
Loosen the Trunnion Locks and slightly move the Table. If the Table does not
automatically stop at 0 degrees use a small screwdriver to adjust the Setscrew
stop. The Table should stop at 0 degrees each time.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.