Filter
Top Products
Page 27SKU 96067
For technical questions, please call 1-800-444-3353.
TO INSTALL THE RIP FENCE AND TOP GUARD
Slide the Rip Fence onto the front and back Tubular Guides, and align the Rip
Fence with the edge of a table slot. Then tighten the front Lock.
(See Figure M and Assy. Diagram, page 50.)
Align the mounting hole at the rear of the Top Guard with the threaded mounting
hole at the rear of the Table. Then tighten the Handle to secure the Top Guard in
place. (See Figure M and Assy. Diagram, page 50.)
1.
2.
FIGURE M
TO INSTALL THE MITER GAUGE
Remove the Knurled Knob from the mounting post on the Miter Gauge. Slip the Clamp
into the slot on the Miter Gauge Handle. Then, reinstall the knurled Knob. Make sure to
screw the knurled Knob down through the Clamp to hold it in place. (See Figure N and
Assy. Diagram, page 56.)
FIGURE N