Filter
Top Products
Page 28SKU 96067
For technical questions, please call 1-800-444-3353.
TO INSTALL THE DISC SANDER
Insert the Sanding Disc Arbor into the Collet, and insert the Collet into the Quill.
Then tighten the Drawrod. Move the saw Table to about 1/16” from the sanding
surface. Adjust the height of the Table to about 1” below the centerline of the
Disc Sander. (See Figure O and Assy. Diagram, page 53.)
NOTE: If your workpiece requires beveled sanding, tilt the Table to the desired
angle. Then adjust the Table’s inside edge height so that it is still about 1” below
the centerline of the Disc Sander. (See Figure O and Assy. Diagram, page 53.)
1.
2.
FIGURE O
TO SET UP THE VERTICAL DRILL PRESS
Mount the saw Table and tilt it 90 degrees. Move the Powerhead and Carriage
into the approximate positions you will need for the drilling task at hand. Then
lock the Powerhead and Carriage in place.
(See Figure P, next page.)
Loosen the two Locking Knobs on the Powerhead Support Bracket. Lift the
machine into the vertical Drill Press position. Firmly tighten the Vertical Locking
Knob on the Tailstock Support Bracket.
(See Figure P, next page.)
Remove the saw blade table Insert and install the drill Insert. Adjust the
Powerhead and/or Carriage to the exact position you need. Then, make sure to
retighten all Locking Knobs. (See Figure P, next page.)
CAUTION! When moving the Powerhead or Carriage while the machine is in the
vertical position, make sure to hold the Travel Knob while loosening the Locking
1.
2.
3.
4.