Filter
Top Products
Page 21SKU 96067
For technical questions, please call 1-800-444-3353.
ASSEMBLY INSTRUCTIONS
TO ATTACH THE SHELF TO THE STAND
NOTE: Always wear ANSI approved safety goggles and work gloves during assembly.
NOTE: The assembly procedures will require the help of additional manpower and a
proper lifting device.
Set the Stand upside-down on a dry, at, level oor surface.
(See Figure E.)
Slide the Shelf between the Stand Legs, making sure the holes in the middle
of the Shelf face the rear of the Stand. (The slot in each Stand end is located
toward the front.) (See Figure E and Assy. Diagram, page 37.)
Align each Bolt hole in the ends and back of the Shelf with the hole located in the
middle of each end of the Cabinet.
(See Figure E and Assy. Diagram, page 37.)
Insert a Screw through each hole, and secure with a Washer and a Nut.
(See Figure E and Assy. Diagram, page 37.)
1.
2.
3.
4.
FIGURE E
TO INSTALL THE CASTERS
Position the left Caster with its Foot Wheel (109), used to raise the Stand,
oriented outward from the Cabinet. Then secure the Caster to the Cabinet, using
the Hex Head Screws.
(See Figure F, next page and Assy. Diagram, page 37.)
Position the right Caster with its foot lever oriented outward from the Cabinet.
Then secure the Caster to the Cabinet, using the Hex Head Screws.
(See Figure F, next page and Assy. Diagram, page 37.)
Place the Stand into the upright position.
1.
2.
3.