Filter
Top Products
Page 31SKU 96067
For technical questions, please call 1-800-444-3353.
INSTALLING AND USING THE CUTTER GUARD
This machine comes with a Cutter Guard (800) that can be used with the router,
shaper or drilling opperations. To attach the guard lower and lock the quill to the
desired height. Press the Cutter Guard (800) up onto the quill. Tighten it in place
using the nut and bolt pre-installed into the guard. (See Figure 1 below)
The guard can be pulled up out of the way when needed. (See Figure 2 below)
1.
2.
Cutter Guard
(800)
Bolt and nut that tightens
the Cutter Guard
Insert the Lathe Spur Drive Center in the 3/4” R-8 Collet. Insert the Collet into
the Quill, and tighten the Drawrod.
Insert the Tailstock into the mounting holes on the right of the machine. Lower
the Tailstock to its lowest position until the Tailstock Collars touch the Support
Bracket. Tighten the Hand-Twist Lock between the posts to secure the Tailstock.
Then place the Morse Taper #2 Cup Center in the Tailstock to support the
workpiece at the Tailstock end.
To mount the workpiece, lock the Powerhead and advance the Quill Feed to
engage the workpiece between the Lathe Spur Drive Center and Cup Center.
After rmly seating the workpiece between the Spur Drive and Cup Center, relax
the Quill slightly and lock the Quill Feed.
1.
2.
3.
TO SET UP THE LATHE
FIGURE 2
FIGURE 1