Filter
Top Products
Page 13SKU 96067
For technical questions, please call 1-800-444-3353.
5. Allow the workpiece to turn up to full speed before feeding a tool bit (not
included) into the workpiece. When turning off the Lathe, allow the
workpiece to slow down and stop on its own. Do not press against the workpiece
to stop it.
6. Feed the tool bit into the workpiece gradually. Do not force a tool bit to re-
move material faster than it is designed to cut.
7. Never attempt to remove material stuck in the moving parts of the Lathe
while it is plugged in and/or running.
ROUTER/SHAPER SAFETY RULES
Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the Router/Shaper.
Never leave the Router/Shaper unattended when it is running. Turn off the
Router/Shaper before leaving the work area.
Always feed the workpiece against the rotation of the Cutter.
In addition to the Fence Jig, always use the Disc Guard unless the Cutter is
too short. When routing, use the Fence Jig for piloted router bits, edging, and
facing procedures.
Always make multiple, shallow passes instead of one deep pass.
Make sure to keep hands and ngers away from the Cutter. Whenever
possible, use “pushsticks” and “pushblocks” (neither included) to feed the
workpiece into the Cutter.
Keep all safety guards of the Router/Shaper in place and in proper working
order.
Make sure the workpiece is free from nails and any other foreign object
which could break or otherwise damage the Cutter.
Never start the Router/Shaper under a load. Allow the Router/Shaper to reach
full speed before feeding a workpiece into the Cutter.
Maintain control of the workpiece at all times. Never allow a workpiece to
rest on the moving Cutter without holding on to it.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.