Filter
Top Products
Page 30SKU 96067
For technical questions, please call 1-800-444-3353.
Use the Rip Fence and/or the Miter Gauge to support and guide the workpiece.
NOTE: Make sure to lock the Miter Gauge in place by tightening the Setscrew in
the Guide Bar. (See Figure Q.)
Set the boring depth by adjusting the Depth Gauge on the Quill Feed.
(See page 16.)
TO SET UP THE SHAPER
Install the R8 Collet (653) and draw it in using the Draw bar (SS742). Insert the
Shaper Arbor (661) into the R8 Collet. Attach a shaper cutter (not included) using
the assembly shown below, making sure to use the Round Guard (665). (See
Figure R below and page 54 parts list and diagram)
Tighten the end Nut (664) and the Rod (647) to secure the assembly. (See
Figure R and page 53)
Raise the Table or extend the Quill until you have the desired depth then tighten
the Quill Feed Lock.
2.
3.
1.
2.
3.
TO SET UP THE ROUTER
The Router setup is the same as the Shaper except that you will need a different
Collet and Guard.
Use the appropriate size Collet (normally 1/2”) and Guard. Insert the Collet in
the Spindle. Tighten the Collet with the Drawbar a few threads. Then insert the
Router Bit in the Collet and tighten.
Extend the Quill and lock it in place. Slide the Router Guard over the Quill. Once
you have adjusted the cutting depths lock the Guard in place. (See page 29)
Always feed the workpiece into the Router Bit’s rotation (left to right).
1.
2.
3.
4.
Shaper Cutter goes
here
Figure R
Round Guard