Filter
Top Products
Page 32SKU 96067
For technical questions, please call 1-800-444-3353.
FIGURE S
MACHINE ADJUSTMENT INSTRUCTIONS
TO ADJUST THE TORSION SPRING TENSION
Move the Carriage and Powerhead all the way to the right end of the Way Tubes
and lock them in place.
Loosen the Way Tube’s Locking Knobs. Make sure the Way Locks on the
Carriage and Powerhead are securely tightened.
Lift the Way Tubes, Carriage, and Powerhead to the vertical Drill Press position.
Then lock the vertical Locking Knob.
Locate the Pivot Hub on the back of the Metal/Woodworking Machine opposite
the Vertical Lock Knob. Look into the holes in the Pivot Hub. You should
observe part of the holes drilled in the base showing through.
Use the Spanner Wrench provided to rotate the Pivot Hub counterclockwise
until the slack is taken up. Continue turning the Wrench counterclockwise until
a set of holes in the Pivot Hub line up. Install all three Socket Head Capscrews
and tighten. (The numbers shown in Figure T are for your reference and do not
appear on the Metal/Woodworking Machine.)
Make sure to rst tension the Spring at one hole in the Pivot Hub, install and
tighten the Bolts, and then test by lowering and lifting the Powerhead. If you
desire still more tension for easier lifting, rotate the Pivot Hub one more set of
holes counterclockwise.
1.
2.
3.
4.
5.
6.