Filter
Top Products
Page 14SKU 96067
For technical questions, please call 1-800-444-3353.
HORIZONTAL BORING SAFETY RULES
Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the Router/Shaper.
Never leave the Router/Shaper unattended when it is running. Turn off the
Router/Shaper before leaving the work area.
Always place scrap wood behind the workpiece to prevent damage to the
drill bit and to avoid splintering.
Always rmly support and guide the wood before and during drilling.
Use only the speeds listed in the Speed Chart.
Make sure the bit never touches the Table, Rip Fence, or Miter Gauge.
Keep your body away from the drill bit when it is exposed and rotating.
Keep all safety guards in place and in proper working order.
Make sure the workpiece is free from nails and any other foreign object
which could break or otherwise damage the drill bit.
Never start the the machine under a load. Allow the machine to reach full
speed before feeding a drill bit into the workpiece.
DISC SANDER SAFETY RULES
Always stand on the left of the Sanding Disc’s center. Never stand on the
right side of center.
Keep hands and ngers away from the Sanding Disc and the nearest edge
of the Table.
Use only the speeds listed in the Speed Chart.
Hold the workpiece rmly when feeding it into the Sanding Disc.
Use only enough pressure to touch the workpiece lightly against the
Sandpaper on the Disc.
Before sanding, turn on the Disc Sander and check for excessively loose
Sanding Disc.
Allow the Sanding Disc to spin up to full speed before feeding a workpiece
into it. Do not ever feed a workpiece past the center line of the disc. When
turning off the Disc Sander, allow the Sanding Disc to slow down and stop on its
own. Do not press against the Sanding Disc to stop it.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1.
2.
3.
4.
5.
6.
7.