Filter
Top Products
See Figure F.21 for steps 17 - 19.
17. With the 9/16" wrench, remove the four bolts and
lock washers holding the case front to the welder
frame. There are two bolts on each side.
18. With the 1/2" wrench, remove the two bolts and
nuts and washers from the gas tank rails - one on
each side.
19. Carefully clear all remaining leads and lift up and
set the front panel assembly to the left side of the
machine. Make sure all leads are clear.
TROUBLESHOOTING & REPAIR
F-44 F-44
SA-250
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
GENERATOR FRAME REMOVAL
AND REPLACEMENT (continued)
FIGURE F.21 – CASE FRONT REMOVAL
STEP #19
STEP #18
STEP #17