Filter
Top Products
© National Instruments Corporation 21 MID-7654/7652 Servo Power Motor Drive User Guide
Figure 11. Protection Cover and Protection Plates:
Used Axes 1 & 2, Unused Axes 3 & 4.
Note
The protection plates for any unused axes should remain installed in the closed
position at all times, as shown on axes 3 and 4 in Figure 11. For axes you are using, the
protection plates must be removed, rotated, and re-installed in the open position, as shown
onaxes1and2inFigure11.
Contact your National Instruments sales representative to replace lost protection plates
(part number 188063A-01).
4. Remove the protection cover using the following procedure:
a. Remove the two screws that attach the protection cover to the side
of the bottom mounting plate, as shown in Figure 10.
b. Lift the protection cover from the slot on the bottom mounting
plate, as shown in Figure 9.
5. Plug the servo motor cables into the servo motor terminals of the
MID-7654/7652. The cables must be placed over the bottom mounting
plate of the rear guard.
6. Re-attach the protection cover
a. Insert the tab of the protection cover, shown in Figure 9, into the
slot on the bottom mounting plate.
b. Lower the protection cover over the servo motor cables and secure
it to the side of the bottom mounting plate using the two screws
youremovedinstep4.
1ProtectionCover 2ProtectionPlate