Filter
Top Products
MID-7654/7652 Servo Power Motor Drive User Guide 30 ni.com
Figure 24. MID-7654/7652 with the Panel Mount Kit Installed
Note
The strain-relief bar and panel mount kit cannot be installed at the same time,
because they will not simultaneously fit under the sides of the bottom mounting plate.
Modifying the Power Entry Module
This section covers replacing fuses and switching the line voltage for
your drive.
Replacing a Fuse
Follow these steps to replace a fuse on your MID-7654/7652:
1. Pry open the hinged cover on the power entry module (number 7 in
Figure 6).
2. Remove the fuse holder. Notice how the fuse holder is oriented so you
can replace it properly.
3. Replace the blown fuse in the fuse holder. Be sure the new fuse is
oriented in the same way as the original fuse, and that it is rated at the
proper voltage.
1 Rear Guard Assembly 2 Panel Mount
NATIONAL
INSTRUMENTS
1
2