Filter
Top Products
10-14
Chapter 10 HXYX
3-4 ZH
(Arm type, gantry type, moving arm type 3rd-axis option/
XZ type 2-axis model)
!
CAUTION
If the fitting length is less than 9mm, the threads could be damaged during
tightening. If the screw length exceeds 27mm from the installation surface, the
screw could contact the bottom.
When using the 3rd-axis model with ZH for the 3rd-axis, install the workpiece
onto the ZH frame in the following manner.
M6 coarse thread tap holes are opened on the frame's workpiece installation sur-
face. Install the tool using these holes. The tap depth is 10mm.
Select the under head length of the installation bolt so that the screw length from
the installation surface is 9mm or more, 27mm or less.
Fig. 10-13 Tool installation ZH
NOTE
There is a step on the ZH frame.
The actual tool installation surface is the shaded section shown above.
100
10
17
2222
78
Refer to the XY-X Series catalog
for the installation position.