Filter
Top Products
11-9
Chapter 11 FXYBX/SXYBX
Select the under head length of the bolt for fixing the tool so that the screw length
from the slider installation surface is 6mm or less.
!
CAUTION
Note that if the screw length from the installation surface is 16mm or more, the
screw will contact the bottom.
3-3 SXYBX-ZF (XZ type 2-axis, arm type 3rd-axis option)
When using the XZ type 2-axis model or if ZF is attached for the arm type 3rd-
axis model, install the workpiece onto the ZF slider in the following manner.
Four M5 coarse thread tap holes and a φ5 reamer hole are opened on the slider’s
workpiece installation surface. Use these to install the tool.
Four M5 coarse thread tap holes are also opened on the slider side. Use these as
required.
Fig. 11-11 ZF
Select the maximum length so that the screw length of the tool fixing bolt is
12mm or less.
The screw fitting length should be 8mm or more.
!
CAUTION
Note that if the screw length from the installation surface is 12mm or more, the
screw will contact the bottom.
2-φ5H7 Depth15
110
4-M5×0.8 Depth12
86
100
(Tolerance between knock (0.02)
70
9 9
50 18
10
4-M5×0.8 Depth9
Stroke cover
91