10 Getting Started
MX3 Reference Guide E-EQ-MX3RG-J-ARC
Power On and Off
Turn On the MX3
Press and hold the Power button until the display turns on. The power button is located above the
ESC key on the keypad.
Figure 1-8 Location of the Power Button
When the MX3 is powered on, the display will begin scrolling power-on information as software
and drivers are loaded. When the display has stopped scrolling and a DOS C: prompt is displayed
or an application begins, the power on sequence is complete.
Turn Off the MX3
Hold the Power button down. The unit will emit three short beeps and one long beep. After the
long beep the MX3 will power down. The Power button and the display will turn off. The Power
key function is configured in the BIOS Setup.
Note: Tapping the Power button will place the MX3 in Suspend mode.
Troubleshooting
The MX3 will not turn off – force a Power Off by holding the Power key down for 15 seconds
and the MX3 will power off. Locate and correct the problem before powering the MX3 back on –
e.g. IRQ conflict, very low battery power, radio conflict, unexpected software application result,
etc.
