Configuration and Sample Files 69
E-EQ-MX3RG-J-ARC MX3 Reference Guide
Cisco Radio NET.CFG File
See Chapter 6, “RF Network Configuration”, for explanations of NET.CFG
parameters.
;Configuration settings for LSL.COM (Link Support Layer)
; Buffers 4 1550 : required to avoid "Network jammed" message in
; : Clarkson Terminal Emulator
Link Support
BUFFERS 4 1550
;Configuration for Packet Driver shim. This shim is used by
;Clarkson Terminal Emulator (CUTE) and other 3rd party protocol
;stacks.
; BIND CSCODI : binds to the Cisco 350 driver
Protocol ODIPKT
Bind CSCODI
file handles=60
LINK DRIVER CSCODI
;Initialization file for Infrastructure operating mode
; NOTE: The following are some keyword parameters that may
;be modified. Any commented or omitted keyword parameter
;assumes the factory default. For most situations the
;factory defaults will be appropriate. In situations where
;the factory default needs to be modified, uncomment or add the
;keyword parameter line and set the appropriate keyword value.
SSID "" ;Must match Access Point setting
;NodeName "" ;Descriptive station name
LEAP "OFF" ;LEAP authentication (OFF -or- ON)
PowerSaveMode "FASTPSP" ;Power save modes (CAM, FASTPSP, PSP)
MaxPowerSave "ON" ;Maximum power save mode (OFF -or- ON)
;WorldMode "OFF" ;World mode (OFF -or- ON)
;ShortPreamble 0 ;PLCP short preamble (0=auto,1=long, 2=short)
;FragThreshold 2312 ;Packet size to start fragmenting
;RTSThreshold 2312 ;Packet size to start sending RTS/CTS
;DataRate1 0x02 ;(1) Mbps supported data bit rate
;DataRate2 0x04 ;(2) Mbps supported data bit rate
;DataRate3 0x0B ;(5.5) Mbps supported data bit rate
;DataRate4 0x16 ;(11) Mbps supported data bit rate
;RefreshInterval 10000 ;Inactivity time to check association
;To enable WEP uncomment the following line and set the
;key with the wepdos.exe utility
authtype "open" ; Set WEP key in radio before wepopen
; (WEPOPEN, WEPSHARED, MIXEDOPEN, MIXEDSHARED)
;The diversity parameter must be set according to the
;number of antennas for each terminal.
;setting for MX1, MX3 = on
;setting for 1380,1390,VX1,VX2,VX4 = right
;setting for 2325,MX2 = right
diversity "on" ; for use on terminals with 2 antennas
;diversity "left"; for use on terminals with 1 antenna left port
;diversity "right"; for use on terminals with 1 antenna right port
;The adapter needs 32 16-bit I/O ports, and 1 non-sharable IRQ.
;The following lines should be uncommented and the appropriate
;values set in the following scenarios:
; 1) PCMCIA mode: Override the I/O port base and/or IRQ
