Filter
Top Products
A-7
Cisco 819 Integrated Services Routers Software Configuration Guide
OL-18906-02
Appendix A Cisco IOS Software Basic Skills
Saving Configuration Changes
Saving Configuration Changes
You must enter the copy running-config startup-config command to save your configuration changes
to NVRAM so that they are not lost if there is a system reload or power outage. This example shows how
to use this command to save your changes:
Router# copy running-config startup-config
Destination filename [startup-config]?
Press Return to accept the default destination filename startup-config or enter your desired destination
filename and press Return.
It might take a minute or two to save the configuration to NVRAM. After the configuration has been
saved, the following message appears:
Building configuration...
Router#
Summary
Now that you have reviewed some Cisco IOS software basics, you can begin to configure your router.
Remember:
• You can use the question mark (?) and arrow keys to help you enter commands.
• Each command mode restricts you to a set of commands. If you are having difficulty entering a
command, check the prompt, and then enter the question mark (?) for a list of available commands.
You might be in the wrong command mode or using the wrong syntax.
• To disable a feature, enter the keyword no before the command; for example, no ip routing.
• Save your configuration changes to NVRAM so that they are not lost if there is a system reload or
power outage.
Where to Go Next
To configure your router, go to the “Basic Router Configuration” section on page 5-1.