Filter
Top Products
5-4
Cisco 819 Series Integrated Services Router Software Configuration Guide
OL-23590-02
Chapter 5 Basic Router Configuration
Information Needed for Configuration
• If you are setting up IP routing:
–
Generate the addressing scheme for your IP network.
• If you are setting up the serial interface:
–
Mode of operation (sync, async, bisync)
–
Clock rate depending on the mode
–
IP address depending on the mode
• If you are setting up 3G:
–
You must have service availability on the Cisco 819 ISR from a carrier, and you must have
network coverage where your router will be physically placed. For a complete list of supported
carriers, see the data sheet at
Cisco 3G Wireless Connectivity Solutions.
–
You must subscribe to a service plan with a wireless service provider and obtain a SIM card.
–
You must install the SIM card before configuring the 3G Cisco 819 ISR. For instructions on how
to install the SIM card, see
Cisco 800 Series RoutersConfiguring Cisco EHWIC and 880G for
3.7G (HSPA+)/3.5G (HSPA).
• You must install the required antennas before you configure the 3G for Cisco 819 ISR. See the
following URLs for instructions on how to install the antennas:
–
3G-ANTM1919D—See Cisco Multiband Swivel-Mount Dipole Antenna (3G-ANTM1919D).
–
3G-ANTM1916-CM—See Cisco Multiband Omnidirectional Ceiling Mount Antenna
(3G-ANTM1916-CM).
–
3G-AE015-R (Antenna Extension)—See Cisco Single-Port Antenna Stand for Multiband TNC
Male-Terminated Portable Antenna (Cisco 3G-AE015-R).
–
3G-AE010-R (Antenna Extension)—See Cisco Single-Port Antenna Stand for Multiband TNC
Male-Terminated Portable Antenna (Cisco 3G-AE015-R). This document applies to both
3G-AE015-R and 3G-AE010-R. The only difference between these two products is the length
of the cable.
–
3G-ANTM-OUT-OM—See Cisco 3G Omnidirectional Outdoor Antenna
(3G-ANTM-OUT-OM).
–
3G-ANTM-OUT-LP—See Cisco Multiband Omnidirectional Panel-Mount Antenna
(3G-ANTM-OUT-LP).
–
3G-ACC-OUT-LA—See Cisco 3G Lightning Arrestor (3G-ACC-OUT-LA).
–
4G-ANTM-OM-CM—See Cisco 4G Indoor Ceiling-Mount Omnidirectional Antenna
(4G-ANTM-OM-CM).
• You must check your LEDs for signal reception as described in Table 2-1.
• You should be familiar with the Cisco IOS software. See the Cisco IOS documentation beginning
with Release 12.4(15)T or later for Cisco 3G support.
• To configure your 3G data profile, you will need the username, password, and access point name
(APN) from your service provider:
After you have collected the appropriate information, you can perform a full configuration on your
router, beginning with the tasks in the
“Configuring Command-Line Access” section on page 5-5.
To obtain or change software licenses:
• See Software Activation on Cisco Integrated Services Routers and Cisco Integrated Service Routers
G2.