Filter
Top Products
6-16
Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
OL-27644-01
Chapter 6 Installing and Upgrading Internal Modules and FRUs
Overview of the SSD Carrier Card NIM (NIM-SSD)
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
Before you begin, read the following important notices:
• The form-factor internal hard drive is accessible from the front panel of the Cisco ISR 4451-X and
supports the online insertion and removal feature (OIR) using the following CLI commands for the
standby and active RP2:
–
request platform hardware filesystem harddisk: offline (Unmounts the hard disk on the
active RP2.)
–
To verify once the SSD drive is installed in the router, use the show platform command. The
following example shows a sample output for a NIM SSD installed:
Router# show platform
Chassis type: ISR4451/K9
Slot Type State Insert time (ago)
--------- ------------------- --------------------- -----------------
0 ISR4452/K9 ok 15:57:33
0/0 ISR4451-6X1GE ok 15:55:24
g0/3 NIM-SSD ok 15:55:24
1 ISR4451/K9 ok 15:57:33
1/0 SM-1T3/E3 ok 15:55:24
2 ISR4451/K9 ok 15:57:33
2/0 SM-1T3/E3 ok 15:55:24
R0 ISR4451/K9 ok, active 15:57:33
F0 ISR4451-FP ok, active 15:57:33
P0 Unknown ps, fail never
P1 XXX-XXXX-XX ok 15:56:58
P2 ACS-4450-ASSY ok 15:56:58
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------------------------
0 12090323 15.3(01r)S [ciscouser-ISRRO...
1 12090323 15.3(01r)S [ciscouser-ISRRO...
2 12090323 15.3(01r)S [ciscouser-ISRRO...
R0 12090323 15.3(01r)S [ciscouser-ISRRO...
F0 12090323 15.3(01r)S [ciscouser-ISRRO...
• The reason you would be removing an internal hard drive is that it is failing or failed; so any data
recovery may be lost.
• If the drive is functioning, you can back it up to a drive plugged into a USB port using the archive
tar command.
Removing the NIM-SSD from the Router
To remove the SSD NIM from the Cisco ISR 4451-X, follow this procedure:
Step 1 Slip on the ESD-preventive wrist strap that was included in the accessory kit. Loosen the screw fasteners
(11) located on the SSD slots on the right of the input/output (I/O) side of the Cisco ISR 4451-X.
(Figure 6-12).