Filter
Top Products
WARNING: To reduce the risk of injury from laser radiation or damage to the equipment, observe
the following precautions:
• Do not open any panels, operate controls, make adjustments, or perform procedures to a laser
device other than those specified herein.
• Do not stare into the laser beam.
CAUTION: Transceiver modules can be damaged by electrostatic discharge (ESD). To prevent ESD
damage to the transceiver module, take the following precautions:
• Wear an antistatic discharge strap while handling transceiver modules.
• Place transceiver modules in antistatic packing material when transporting or storing them.
Steps
1. Position the transceiver module so that the key is oriented correctly to the port in the storage
controller.
Figure 33. Install the SFP+ Transceiver Module
1. SFP+ transceiver module 2. Fiber-optic cable connector
2. Insert the transceiver module into the port until it is firmly seated and the latching mechanism clicks.
The transceiver modules are keyed so that they can only be inserted with the correct orientation. If a
transceiver module does not slide in easily, ensure that it is correctly oriented.
CAUTION: To reduce the risk of damage to the equipment, do not use excessive force when
inserting the transceiver module.
3. Position fiber-optic cable so that the key (the ridge on one side of the cable connector) is aligned
with the slot in the transceiver module.
CAUTION: Touching the end of a fiber-optic cable damages the cable. Whenever a fiber-
optic cable is not connected, replace the protective covers on the ends of the cable.
4. Insert the fiber-optic cable into the transceiver module until the latching mechanism clicks.
5. Insert the other end of the fiber-optic cable into the SFP+ transceiver module of a Fibre Channel
switch.
Remove an SFP+ Transceiver Module
Complete the following steps to remove an SFP+ transceiver module from a 16 Gb FC storage controller.
Prerequisites
Use failover testing to make sure that the connection between host servers and Storage Center remains
up if the port is disconnected.
Front-End Cabling
43