Filter
Top Products
Configure Embedded iSCSI Ports
Configure the embedded Ethernet ports on the Storage Center for use as iSCSI ports.
1. Configure the fault domain and ports for iSCSI Embedded Domain 1.
a. Enter the target IPv4 address, subnet mask, and gateway for the fault domain.
b. Enter an IPv4 address for each port in the fault domain.
NOTE: Make sure that all the IP addresses for iSCSI Embedded Domain 1 are in the same
subnet.
2. If the Flex Port license is installed, configure the fault domain and ports for Flex Port Domain 1.
a. Enter the target IPv4 address, subnet mask, and gateway for the fault domain.
b. Enter an IPv4 address for each port in the fault domain.
NOTE: Make sure that all the IP addresses for iSCSI Embedded Domain 1 are in the same
subnet.
3. Click OK.
Discover and Configure the Storage Center
85