Filter
Top Products
Local Operation
Menu 4
4-23
gld23.bmp
Figure 4-21. Menu | Program | Config - Menu
5. Press PREVIOUS until the Main Menu appears.
6. Press Setup [F2] | Limits [F1]. Change the desired parameters using the normal
procedures.
7. Return to the Main Menu by pressing PREVIOUS three times.
8. Press Menu [F6] | Program [F4].
9. Use the rotary knob to highlight the name of the program.
10. Press Config [F3] | Save [F1]. The configuration of the Calibrator will be changed to
the current settings and stored in the program’s configuration.
Running a Program
1. Programs are run from the Program Menu. From the Main Menu (press PREVIOUS
until the Main Menu appears), press Menu [F6] | Program [F4].
2. Use the rotary knob to highlight the name of the program.
3. Press Run [F1]. The program run screen will appear. “Stop” will be highlighted,
showing that the program is not currently running.
gld24.bmp
Figure 4-22. Menu | Program | Run - Menu