Filter
Top Products
IPS Anomaly CLI configuration
FortiGate-100A Administration Guide 01-28007-0068-20041203 287
Anomaly CLI configuration
(config ips anomaly) config limit
Access the config limit subcommand using the config ips anomaly
<name_str> command. Use this command for session control based on source and
destination network address. This command is available for tcp_src_session,
tcp_dst_session, icmp_src_session, icmp_dst_session,
udp_src_session, udp_dst_session.
You cannot edit the default entry. Addresses are matched from more specific to
more general. For example, if you define thresholds for 192.168.100.0/24 and
192.168.0.0/16, the address with the 24 bit netmask will be matched first.
Command syntax pattern
config limit
edit <name_str>
set <keyword> <variable>
end
config limit
edit <name_str>
unset <keyword>
end
config limit
delete <name_str>
Example
Use the following command to configure the limit for the tcp_src_session
anomaly.
config ips anomaly tcp_src_session
config limit
edit subnet1
set ipaddress 1.1.1.0 255.255.255.0
set threshold 300
end
end
Note: This guide only covers Command Line Interface (CLI) commands that are not
represented in the web-based manager. For complete descriptions and examples of how to use
CLI commands see the FortiGate CLI Reference Guide.
Note: This command has more keywords than are listed in this Guide. See the FortiGate CLI
Reference Guide for a complete list of commands and keywords.
limit command keywords and variables
Keywords and variables Description Default Availability
ipaddress
<address_ipv4mask>
The ip address and netmask of the
source or destination network.
No
default.
All models.
threshold
<threshold_integer>
Set the threshold that triggers this
anomaly.
No
default.
All models.