Filter
Top Products
Model G0763 (Mfg. Since 8/13)
-19-
6. Assemble ball bearing segments into two
strips of equal size (four segments each).
7. Apply medium coat of NLGI#2 grease to ball
bearing strips.
8. Position ball bearing strips in middle of sad-
dle ways, as shown in Figure 16.
9. With the help of another person, gently place
table right side up on ball bearing strips.
10. Feed table cable under table so that attached
cable barrel is on the right of machine, as
shown in Figure 17.
11. Secure barrel to table with (1) M10-1.5 x 50
cap screw.
Note: When cable is properly wrapped
around pulley in next step, have another
person maintain enough tension on cable so
that it stays in pulley grooves until it can be
secured in following steps.
12. Wrap cable around pulley twice, as shown in
Figures 18–19.
Note: Pay close attention to position and
orientation of cable on pulley, as illustrated in
Figure 18.
To the
Left End
To the
Right End
Open End
of Pulley
Figure 18. Cable orientation on pulley.
13. While maintaining cable tension, move table
back and forth several times to ensure cable
position on pulley allows full travel of table.
— If the cable position on the pulley does not
allow full travel of table, reposition cable on
pulley until it does.
Figure 16. Ball bearing strips positioned on
saddle ways.
Ball Bearing Strips
Figure 17. Cable barrel attached.
Cable Barrel
x 1
Figure 19. Cable on pulley, as viewed from left
end of table.
Open End
of Pulley