Filter
Top Products
-22-
Model G0763 (Mfg. Since 8/13)
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly setup machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
2. Install a strain relief in available hole in bot-
tom of electrical cabinet, then pull incoming
power cord through strain relief.
3. Connect incoming hot wires to bottom of first
two terminal bar connectors, then connect
incoming ground wire to grounding bar (refer
to the Electrical Cabinet Wiring Diagram
on Page 42 for additional details).
4. Leave slack in wires inside cabinet, tighten
strain relief to secure cord, then tug on power
cord outside electrical cabinet to make sure
wires do not move inside cabinet.
— If wires do move when you tug on power
cord outside electrical cabinet, disconnect
wires, reposition cord, then tighten strain
relief so that cord will not move when
tugged on. Reconnect wires as instructed
in Step 3.
5. Close electrical cabinet door, but leave mas-
ter power switch OFF.
6. Attach a NEMA 6-15 plug to other end of
power cord per manufacturer's directions
(refer to Electrical Cabinet Wiring Diagram
on Page 42 for additional details).
7. Connect machine to power source by insert-
ing power cord plug into a matching recep-
tacle.
Te s t R u n
Once assembly is complete, test run the machine
to ensure the following components are working
properly:
• Grinding motor
• Coolant pump
• Emergency STOP button
• Table power feed
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table on
Page 39 can help.
You MUST understand the function of the controls
to safely complete the Test Run. If you are not
sure how a control functions or where it is, refer to
Basic Controls beginning on Page 4.
To test run the machine:
1. Push Emergency STOP button in.
2. Remove all tools used for setup from the
machine.
3. Fill and operate the one-shot oiler (refer to
Lubrication on Page 36 for detailed instruc-
tions).