Filter
Top Products
-34-
Model G0763 (Mfg. Since 8/13)
SECTION 6: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
To keep this machine in the best operating condi-
tion, make sure to complete the following mainte-
nance items within the minimum intervals listed
below.
Daily:
• Use/fill one-shot oiler (Page 36).
• Check/fill coolant tank.
• Check/correct loose mounting bolts.
• Check/replace damaged or cracked grinding
wheel.
• Check/correct worn or damaged wires.
• Clean and protect machine.
• Correct any other unsafe condition.
Monthly:
• Drain oil sump (Page 36).
• Lubricate table ball bearing strips (Page 36).
• Check/change coolant (Page 37).
Schedule
Cleaning &
Protecting
Typically, the easiest way to clean swarf from
the table is to use a wet/dry shop vacuum that is
dedicated for this purpose only. The small chips
left over after vacuuming can be wiped up with a
slightly oiled rag. Avoid using compressed air to
blow off chips, as it may drive them deeper into
moving surfaces and could cause sharp chips to
fly into your face or hands.
The magnetic chuck and the unpainted table sur-
face underneath the chuck should be wiped down
daily to keep them rust-free and in top condition.
Then apply a thin film of ISO 32 oil to provide pro-
tection (see Page 34 for an offering from Grizzly).