Filter
Top Products
Model G0763 (Mfg. Since 8/13)
-21-
21. Position splash guard base on table with
high end to the left of machine, as shown in
Figure 24.
22. Secure splash guard base with (4) M6-1 x 12
cap screws, as shown in Figure 24.
23. Insert splash guard sides into slots on each
side of splash guard base, as shown in
Figure 25.
Power Connection
Before the machine can be connected to the
power source, an electrical circuit must be made
available that meets the minimum specifications
given in Circuit Requirements for 220V on
Page 11. If a power circuit has not been prepared
for the machine, do that now.
To ensure a safe and code-compliant setup, all
electrical work must be done by an electrician or
qualified service personnel.
To connect the power supply to the machine:
1. Turn master power switch OFF (see
Figure 26), then press latch to open electri-
cal cabinet door.
Figure 24. Splash guard base attached.
x 4
Splash Guard
High End
Figure 25. Splash guard sides installed.
Splash Guard
Sides
Figure 26. Location of master power switch.
Master
Power Switch