Filter
Top Products
Model G0763 (Mfg. Since 8/13)
-29-
3. Thread wheel flange onto sleeve then tighten
it with wheel flange wrench until it is snug
(see Figure 34)—overtightening may crack
wheel.
Note: Flange has left-handed threads and
threads onto sleeve counterclockwise.
4. Loosen the knurled knobs shown in Figure
35, then remove wheel guard front cover.
7. Re-install wheel guard front cover before
reconnecting machine to power.
Figure 34. Threading wheel flange onto wheel
sleeve.
Flange
Wrench
Wheel
Flange
Figure 36. Wheel assembly and arbor nut
installed.
Arbor
Nut
5. Using a slightly-oiled lint free cloth, wipe mat-
ing surfaces of machine arbor and internal
sleeve taper perfectly clean, then slide wheel
assembly onto arbor.
6. Thread arbor nut onto arbor (see Figure 36)
and tighten it until snug—overtightening may
crack wheel.
Note: Arbor nut has left-handed threads and
threads onto arbor counterclockwise.
Figure 35. Wheel guard components.
Knobs
Wheel Guard
Front Cover