Filter
Top Products
Model G0763 (Mfg. Since 8/13)
-37-
Check/Adding Coolant
Lift the coolant tank lid shown in Figure 48 to
check the coolant level. If necessary, add coolant
until the level is a couple of inches from the top
of the tank.
The coolant tank holds approximately 8 gallons
of fluid.
Use a high-quality, water-soluble oil coolant
that is non-flammable. Generally, synthetics
last longer.
Changing Coolant
Items Needed Qty
5 Gallon Buckets w/Lids .................................... 2
Hex Wrench 5mm .............................................. 1
Standard Screwdriver #2 ................................... 1
To change coolant:
1. DISCONNECT MACHINE FROM POWER!
2. Remove return hose and both lids from tank.
3. Empty tank contents into buckets and dis-
pose of fluid following federal, state, and fluid
manufacturer requirements.
4. Thoroughly clean tank and pump with hot
soapy water.
5. When dry, refill tank with coolant (approxi-
mately 8 gallons).
6. Replace lids and return hose.
Wheel Storage
Store grinding wheels in a dry area that is not sub-
ject to extreme temperature changes or freezing.
Some abrasive bonds may be adversely affected
by excessive humidity, dampness, or extreme
temperature changes.
Store the wheels on edge (vertically) in racks that
provide a cushioned two-point cradle support to
prevent rolling. Also, provide partitions that pre-
vent the wheels from tipping over.
Figure 48. Coolant tank components.
Return
Hose
Tank Lid
Coolant
Pump