Filter
Top Products
-20-
Model G0763 (Mfg. Since 8/13)
14. Secure table cable bracket underneath left
end of table with (2) M10-1.5 x 25 cap
screws, as shown in Figure 20.
15. Thread hex bolt attached to end of cable into
cable bracket until cable tension is enough
to keep cable tightly wrapped around pulley
(see Figure 21).
17. Attach table ends to table with (4) M8-1.25 x 12
cap screws (see Figure 22).
18. Stone and clean any burrs from unpainted
table surface and bottom of magnetic chuck,
then apply a thin coat of ISO 32 oil to both
surfaces.
19. With help from another person, position
magnetic chuck in center of table with chuck
control facing to front, as shown in Figure 23.
20. Secure magnetic chuck to table with (2)
clamp assemblies, as shown in Figure 23.
16. Tighten jam nut against bracket to secure
position of hex bolt.
Figure 20. Cable bracket installed.
x 2
Cable
Bracket
Figure 21. Cable attached to cable bracket.
Hex Bolt
Jam Nut
Figure 22. Table end attached.
Table
End
2
of 4
Figure 23. Magnetic chuck attached to table.
Clamp Assemblies
Chuck Control