Filter
Top Products
-24-
Model G0763 (Mfg. Since 8/13)
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the
machine controls/components
discussed later
in this manual
are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and
seek additional training from expe
-
rienced
machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To complete a typical operation, the operator
does the following:
1. Examines the grinding wheel to make sure it
is suitable for use.
2. Examines the workpiece to make sure it is
properly prepared for grinding.
3. Uses the Z-axis handwheel to raise the grind-
ing wheel assembly to provide clearance for
mounting the workpiece.
4. Uses the magnetic chuck to hold the
workpiece to the table, then turns the Z-axis
handwheel to lower the grinding wheel to just
above the top surface of the workpiece.
5. Turns the grinder ON, then waits until the
wheel reaches full speed.
6. Performs the grinding operation.
Note: Because the method for perform-
ing each grinding operation varies, specific
actions are not listed here.
7. When the grinding operation is complete,
turns the grinder OFF and allows the grinding
wheel to come to a complete stop.
8. Removes the workpiece from the table.
Damage to eyes, respiratory system, or feet
could result from using this machine with-
out proper protection. Always wear eye pro-
tection, respirator, and leather boots with
extra toe protection.