Filter
Top Products
Digital Dosing Units
9
Recipe Setup for Injection Molding:
1. Turn power switch to ON position.
2. Press Input to display # 1, “Additive %”. Using arrow keys, set additive ratio.
3. Press Input
to display #2, “Shot size of current mold”. Using arrow keys, set the
total shot size (parts and runners) of the current mold capacity in grams/pounds.
4. Press Input to display # 3, “Screw recovery time”. Using arrow keys, set the
screw recovery time (in seconds).
5. Press Input to display # 4, “Calibration weight for additive”. Enter the appropriate
value from the range table below and proceed to calibration mode below for calibration
of additive material.
DD Discs
Disc Calibration Number
Range
DD 30-030672 1.75
DD 30-051040 5.00
DD 30-051725 8.00
DD 30-051818 15.00
DT Discs
DP Discs
Disc Calibration Number
Range
DT 30-101820 32.00
DT 30-102025 38.00
DT 30-203012 100.00
DT 30-204010 175.00
Disc Calibration Number
Range
DP 30-050940 17.00
DP 30-250940 8.00