Filter
Top Products
Prestige 1100 Internet Access Router
12-18 System Maintenance
12.9.4 Boot Module Commands
Prestige boot module commands are shown below. For ATBAx, x denotes the number preceding the colon
to give the baud rate following the colon in the list of numbers that follows; e.g. ATBA3 will give a baud of
9.6 kbps. ATSE displays the seed that is used to generate a password to turn on the debug flag in the
firmware. The ATSH command shows product related information such as boot module version, vendor
name, product model, RAS code revision, etc.
Figure 12-17 Boot module commands
======= Debug Command Listing =======
athe
======= Debug Command Listing =======
AT just answer OK
ATHE print help
ATBAx change baudrate. 1:38.4k, 2:19.2k, 3:9.6k
4:57.6k 5:115.2k
ATENx(,y) set BootExtension Debug Flag (y=password)
ATSE show the seed of password generator
ATTI(h,m,s) change system time to hour:min:sec or show
current time
ATDA(y,m,d) change system date to year/month/day or show
current date
ATDS dump RAS stack
ATDT dump Boot Module Common Area
ATDUx,y dump memory contents from address x for length
y
ATRBx display the 8-bit value of address x
ATRBx display the 8-bit value of address x
ATRWx display the 16-bit value of address x
ATRLx display the 32-bit value of address x
ATGOx run program at addr x or boot ZyNOS
ATGR boot ZyNOS
ATGT run Hardware Test Program
ATRTw,x,y(,z) RAM Test level w, from address x to y (z
iterations)
ATCB copy from FLASH ROM to working buffer
ATSH dump manufacturer related data in ROM
ATDOx,y download from address x for length y to PC via
XMODEM
ATTD download configuration to PC via XMODEM
< press any key to continue >
ATUR upload RAS code to flash ROM
ATUR3 upload RAS configuration file
ATLOa,b,c,d Int/Trap Log Cmd
ATGM boot ZyNOS in main block
ATGB boot ZyNOS in backup block
ATUM upload RAS code to main block
ATUB upload RAS code to backup block
ATSW switch main block and backup block
OK