Filter
Top Products
Prestige 1100 Internet Access Router
Bridge Setup 7-3
Figure 7-2 Menu 11.3 - Remote Node Bridging Options
Table 7-1 describes the bridging-dependent parameters in the Remote Node Profile and Network Layers
menus.
Table 7-1 Remote Node Bridge Options
Field Description
Bridge (Menu 11) Make sure this field is set to [Yes].
Edit IP/IPX/Bridge (Menu 11) Press the space bar to change it to [Yes] and press [ENTER] to go to the
Network Layer Options Menu.
Ethernet Addr Timeout (min)
(Menu 11.3 above)
In this field, enter the time (number of minutes) that you wish your Prestige
1100 to retain the Ethernet Addr information in its internal tables while the
line is down. If this information is retained, your Prestige 1100 will not have
to recompile the tables when the line is brought back up.
Once you have completed filling in the Network Layer Options Menu, press [ENTER] to return to Menu
11.1. Then press [ENTER] at the message [Press ENTER to Confirm…] to save your configuration, or
press [ESC] to cancel.
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Server IP Addr= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
Multicast= IGMP-v2
IP Policies=
IPX Options:
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= 3
SAP/RIP Timeout(min)= 3
Bridge Options:
Ethernet Addr Timeout(min)= 0
Enter here to CONFIRM or ESC to CANCEL: