Filter
Top Products
Prestige 1100 Internet Access Router
Hardware Installation & Initial Setup 2-1
Chapter 2:
Hardware Installation & Initial Setup
2.1 Unpacking your Bridge/Router
This chapter explains how to connect to the hardware and to perform the initial setup. Before installing
be sure that all components listed with the enclosed packing slip are included.
2.2 Additional Installation Requirements
In addition to the contents of your package, there are other hardware and software requirements you
need before you can install and use your Prestige. These requirements include:
l A computer with Ethernet 10Base-T or 100Base-TX NIC (Network Interface Card).
l A computer equipped with communications software configured to the following parameters:
Ø VT100 terminal emulation.
Ø 9600 Baud.
Ø No parity, 8 Data bits, 1 Stop bit.
Ø Flow Control set to None.
After the Prestige is properly set up, you can make future changes to the configuration through telnet
connections.