Filter
Top Products
Prestige 1100 Internet Access Router
7-4 Bridge Setup
7.2.2 Bridge Static Route Setup
Similar to network layer static routes, a bridging static route tells the Prestige 1100 about the route to a
node before a connection is established. You configure bridge static routes in Menu 12.3.1(go to Menu
12, choose option 3, then choose a static route to edit) as shown in Figure 7-3.
Figure 7-3 Menu 12.3.1 - Edit Bridge Static Route
The following Table 7-2 describes the Bridge Static Route Menu.
Table 7-2 Bridge Static Route Menu Fields
Field Description
Route # This is the index number of the route as listed in Menu 12.3 – IPX Static Route
Setup.
Route Name Enter a name for the bridge static route for identification purposes.
Active Indicates whether the static route is active or not.
Ether Address Enter the MAC address of the destination machine that you wish to bridge the
packets to
IP Address If available, enter the IP address of the destination machine that you wish to
bridge the packets to.
Once you have completed filling in this menu, press [ENTER] at the message [Press ENTER to
Confirm…] to save your configuration, or press [ESC] to cancel.
Menu 12.3.1 - Edit Bridge Static Route
Route #: 21
Route Name=
Active= Yes
Ether Address= ?
IP Address=
Press ENTER to CONFIRM or ESC to CANCEL: