Filter
Top Products
Prestige 1100 Internet Access Router
Filter Configuration 8-15
Field Description Option
Log Select the logging option from the following:
l [None] – No packets will be logged.
l [Action Matched] - Only packets that match the rule parameters will
be logged.
l [Action Not Matched] - Only packets that do not match the rule
parameters will be logged.
l [Both] – All packets will be logged.
[None]
[Action
Matched]
[Action Not
Matched]
[Both]
Action
Matched
Select the action for a matching packet.
[Check Next
Rule]
[Forward]
[Drop]
Action Not
Matched
Select the action for a packet not matching the rule.
[Check Next
Rule]
[Forward]
[Drop]
Once you have completed filling in Menu 21.1.1 - Device Filter Rule, press [ENTER] at the message
[Press Enter to Confirm] to save your configuration, or press [ESC] to cancel. This data will now be
displayed on Menu 21.1 - Filter Rules Summary.
8.5 Applying a Filter
This section shows you where to apply the filter(s) after you design it (them).
8.5.1 Ethernet traffic
You seldom need to filter Ethernet traffic; however, the filter sets may be useful to block certain packets,
reducing traffic and preventing security breaches. Go to Menu 3.1 (shown below) and enter the number(s)
of the filter set(s) that you want to apply as appropriate. You can choose up to four filter sets (from twelve)
by entering their numbers separated by commas, e.g., 3, 4, 6, 11.
Figure 8-9 Filtering Ethernet Traffic
Menu 3.1 - General Ethernet Setup
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Press ENTER to Confirm or ESC to Cancel: