Filter
Top Products
Prestige 1100 Internet Access Router
Remote Node Configuration 4-1
Chapter 4:
Remote Node Configuration for LAN to LAN
A remote node is required for placing calls to a remote gateway. A remote node represents both the
gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up
Internet access, you are actually configuring the remote node.
In this chapter, we will discuss the parameters that are protocol independent. The protocol-dependent
configuration will be covered in subsequent chapters.
This section describes the protocol-independent parameters for a remote node.
4.1 Leased Line Remote Node Profile
To configure a remote node, enter 11 to select Menu 11.1 - Remote Node Setup.
Figure 4-1 Menu 11.1 - Remote Node Profile for Leased Lines
The following table contains the instructions on how to configure the Remote Node Menu for leased lines.
Menu 11.1 - Remote Node Profile
Rem Node Name= ?
Active= Yes
Incoming:
Rem Login= ?
Rem Password= ********
Outgoing:
My Login= ?
My Password= ********
Authen= CHAP/PAP
Route= IP
Bridge= No
Edit PPP Options= No
Rem IP Addr= ?
Edit IP/IPX/Bridge= No
Input Filter Sets:
Protocol filters =
Device filters =
Output Filter Sets=
Protocol filters =
Device filters =
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.