Filter
Top Products
-16-
17B@A:2;A@
2?3;@2?A17B@A:2;A
The kerf inserts should be adjusted close to the
blade, but without touching the blade, to avoid tear-
out on the bottom of the workpiece.
1. Hold the saw head assembly down and push in
the head assembly lock pin (item 36 – page 8)
to keep the saw in the DOWN position.
2. Loosen the two kerf insert screws using a #2
Phillips screwdriver.
3. Adjust the kerf inserts as close to the blade
(teeth) as possible without touching the blade.
4. Tighten the kerf screws.
"#' At extreme bevel angles, the saw blade
may slightly cut into kerf insert.
'<.C<616;7B?F3<99<D.99@A.A2
:2;A@612;A63621/29<D/FA52
( ' •@F:/<9
• "2C2?963AA56@@.D/F4?.@=6;4A52/.@22EA2;
@6<;@D52;A52F.?26;A522EA2;121=<@6A6<;
• (;=9B42920A?600<?1.;1D6;1B= Use the hook
and loop strap to hold the wrapped cord together.
• "2C2?963AA52@.D/F4?6==6;4.;F<3A52:205
.;6@:=.?A@ The saw may move and cause se-
vere injuries to your fingers or hands.
• '<.C<61/.086;7B?F5<91A52A<<909<@2A<F<B?
/<1FD52;963A6;4Bend your knees so you can
lift with your legs, not your back.
• "2C2?963AA<<9/F5<916;4@D6A055.;192 This
may cause serious damage to the tool.
• "2C2?963AA52:6A2?@.D/FA52=<D2?0<?1At-
tempting to lift or carry the tool by the power cord
will damage the insulation and the wire connec-
tions, resulting in electric shock or fire.
• $9.02A52@.D<;.36?:92C29@B?3.02D52?2
A52?26@=92;AF<3?<<:3<?5.;196;4.;1=?<=
2?9F@B==<?A6;4A52D<?8=6202
#" ,963AA56@@.D/FA520.@A6;0.??F5.;192@
.A2.05@612<3A52/<AA<:<3A52/.@2 A<=0.??F
5.;192<??2.?0.??F5.;192
$?2=.?6;4'< 63A'52&.D
Set bevel angle at 0° and lock in place using the
bevel lock lever.
Rotate the table to either 45 or 0° and lock into place
using the miter lock knob.
Lock the saw head in the DOWN position with the
head lock pin.
Check that each base table extension is in the
closed position and locked in place (See Figure 18).
2?3;@2?A
&0?2D@
FIG. 17
'?.;@=<?A6;4.;1!<B;A6;4
!
WARNING
BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 16