Filter
Top Products
$?2=.?6;43<?&.D#=2?.A6<;@
*<?8=6202&B==<?A
9.:=@
(@6;4A52*<?8=62029.:=– This clamp easily
secures a workpiece to the table or base.
1. Insert the clamp’s knurled bar down into a clamp
post hole; there are two post holes located in the
base behind the fence. The knurled end must be
in the post at least 1/2".
2. Slide the clamp down until its rubber foot con-
tacts the workpiece.
3. Adjust the clamp height so it does not touch the
sliding fence.
4. Rotate the clamp’s knob until the workpiece is
firmly held in place (See Figure 25).
5. Move saw head up and down and forward and
back to be sure it clears the clamp.
'52?2 :.F /2 2EA?2:2 0<:
=<B;10BA@D52?209.:=0.;;<A
/2B@21&B==<?AD<?8=6202D6A5F<B?5.;1<BA
@612A52M"<.;1@NG<;2<;<AA?FA<0BA
@5<?A=6202@A5.A0.;;<A/209.:=21.;10.B@2
F<B?5.;1A</26;A52M"<.;1@NG<;2
9.:=@ – Other hold-down devices such as C-
clamps can be used to hold the workpiece firmly
against the table and the fence. Make sure the
clamps are clear of the cutting path.
&9616;42;02@
'<=?<C612@B336062;A:6;6:B:
@=.06;43?<:5.;1A<@.D
/9.122EA2;1A52@9616;432;02.;1/.@22EA2;
@6<;@D52;:.86;42EA?2:2/2C29:6A2?<?0<:
=<B;10BA@.
#=2?.A6;4&9616;42;02
1. Pull the fence lock lever toward front of tool to
loosen fence (See Figure 26).
2. Slide fence to the desired position. (See Figure
27)
3. Push the lock lever toward rear of tool to lock
fence position. (See Figure 26)
%2:<C6;4&9616;42;02@
1. Lift up on the cover plate tab and rotate it away
from the fence. (See Figure 26)
2. Push the lock lever toward front of saw to loosen
the fence.
3.
Slide the fence all the way out, away from the saw
head.
4. Lift up on the sliding fence to remove.
&9616;4
2;02
9.:=
*<?8=6202
9A2?;.A6C2
<0.A6<;
!
WARNING
2;02 <08
2C2?
<C2?
$9.A2'./
17B@A:2;A
&0?2D
-20-
FIG. 25
!
WARNING
FIG. 27
FIG. 26
BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 20