Filter
Top Products
6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
43
BAS-300G, BAS-311G, BAS-326G
5
To record another cycle program, repeat steps 2 to 4.
6
End cycle program recording mode.
TEST indicator switches off, MENU indicator illuminates
Press the TEST key.
This completes the recording of cycle programs.
• The cycle program number will flash in the PROGRAM
No. display, and the sewing machine will switch to
home position detection standby.
<Setting method>
1. Press the
or key (1) to select the cycle program
number that you would like to use.
• If the cycle program number is flashing, depress the
foot switch to move the feed mechanism to the home
position. After this, it is not necessary to detect the
home position until the next time the power is turned
off and back on, even if you change the cycle
program number.
• The cycle program number can be selected directly
by pressing function keys F1 to F4 (2). (Refer to "6-9.
Direct selection".)
2. Check that the needle and work clamp do not interfere
with each other, and then start sewing. (Refer to "5-6
Checking the sewing pattern".)
3. The recorded user program will be sewn step by step, and when the final step is complete, the menu display (3) will
return to showing step 1.
• If you press the
or key (4), you can return to the previous step or skip to the next step respectively. (You do not
need to carry out home position detection again.)
• If you press the SELECT key (5), you can check the details (such as X-scale, Y-scale and sewing speed) of the user
program for the displayed step. The setting cannot be changed at this time.
NOTE:
If cycle program sewing mode is active (when memory switch no. 401 is "ON") but no cycle programs have been
recorded, the user programs will be sewn in numeric order.
“C-0” will appear in the PROGRAM No. display at this time.
4439Q
4442Q