Filter
Top Products
8. SEWING
BAS-300G, BAS-311G, BAS-326G
51
8. SEWING
WARNING
Do not allow any liquids to get onto this sewing machine, otherwise fire, electric shocks or operating problems may
occur.
If any liquid gets inside the sewing machine (machine head or control box), immediately turn off the power and
disconnect the power plug from the electrical outlet, and then contact the place of purchase or a qualified
technician.
CAUTION
Turn off the power switch at the following times.
If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result.
• When threading the needle
• When replacing the bobbin and needle
• When not using the machine and when leaving the machine unattended
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.
8-1. Sewing
1. Turn on the power switch.
2. Press the
or key (1) to select the sewing program
number that you would like to use.
* Refer to "5-2. Loading sewing data" for details on
reading sewing data from a CF card.
3. Depress the foot switch to the 2nd step.
(If using a two-pedal foot switch, lower the work clamp
before depressing the start switch (2).)
• The feed mechanism will move to the home position.
4. Place the article to be sewn underneath the work clamp
(3).
5. Depress the foot switch to the 1st step.
(If using a two-pedal foot switch, depress the work
clamp switch (4).)
• The work clamp (3) will drop.
6. Depress the foot switch to the 2nd step.
(If using a two-pedal foot switch, depress the start switch
(2).)
• The sewing machine will start sewing.
7. When sewing is complete, the thread will be trimmed
and the work clamp (3) will rise.
Use a work clamp that hold the article being sewn
firmly, without allowing it to slip.
If using the standard work clamp and feed plate and
the article being sewn is slipping, take measures to
stop the work clamp and feed plate from being
slippery.
4978Q
4441Q
1st step
2nd step
4979Q
2996B