Filter
Top Products
11. TABLE OF ERROR CODES
BAS-300G, BAS-311G, BAS-326G
68
Upper shaft motor-related errors
Code
Cause and remedy
E110
Needle up stop position error.
Turn the machine pulley until the point where the error display disappears.
E111
Upper shaft did not stop at the needle up stop position when the sewing machine stopped.
Turn the machine pulley until the point where the error display disappears.
E120
Needle drop signal could not be detected.
Turn off the power, and then check the synchronizer connection.
E121
Thread trimming was not completed.
Turn off the power, and then check if the cutting edges of the fixed knife and movable knife are damaged or worn.
E130
Sewing machine motor stopped due to a problem, or synchronizer is faulty.
Turn off the power, and then turn the machine pulley and check if the sewing machine has locked up.
Check that connectors P4 and P5 on the power supply motor PCB are properly connected.
E131
Synchronizer is faulty.
Turn off the power, and then check that connector P5 on the power supply motor PCB is properly connected.
E132
Problem detected with sewing machine motor operation.
Turn off the power, and then check that connector P4 on the power supply motor PCB is properly connected.
E133
Sewing machine motor stopping position is incorrect.
Turn off the power, and then check that connector P5 on the power supply motor PCB is properly connected.
E150
Sewing machine motor is overheating, or temperature sensor is faulty.
Turn off the power, and then check the sewing machine motor.
(When sewing data with a small number of stitches (15 stitches or less) is sewn repeatedly (short cycle operation),
the upper shaft motor may overheat and the "E150" error code may be generated.)
Feed mechanism-related errors
Code
Cause and remedy
E200
X-feed motor home position cannot be detected.
Problem with X -feed motor or poor X home position sensor connection.
Turn off the power, and then check that connector P10 on the PMD PCB and connector P20 on the main PCB are
properly connected.
E201
X-feed motor stopped due to a problem.
Turn off the power, and then check if there are any problems in the X-feed direction.
E202
Problem with X-feed motor or Y-feed motor home position adjustment data.
Re-adjust the home position.
E204
X-feed motor stopped due to a problem during sewing.
Turn off the power, and then check if there are any problems in the X-feed direction.
E205
X-feed motor stopped due to a problem while moving to the sewing start position.
Turn off the power, and then check if there are any problems in the X-feed direction.
E206
X-feed motor stopped due to a problem during test feeding.
Turn off the power, and then check if there are any problems in the X-feed direction.
E207
X-feed motor stopped due to a problem during programming.
Turn off the power, and then check if there are any problems in the X-feed direction.
E210
Y-feed motor home position cannot be detected.
Problem with Y-feed motor or poor Y home position sensor connection.
Turn off the power, and then check that connector P8 on the PMD PCB and connector P4 on the main PCB are
properly connected.
E211
Y-feed motor stopped due to a problem.
Turn off the power, and then check if there are any problems in the Y-feed direction.
E214
Y-feed motor stopped due to a problem during sewing.
Turn off the power, and then check if there are any problems in the Y-feed direction.
E215
Y-feed motor stopped due to a problem while moving to the sewing start position.
Turn off the power, and then check if there are any problems in the Y-feed direction.
E216
Y-feed motor stopped due to a problem during test feeding.
Turn off the power, and then check if there are any problems in the Y-feed direction.
E217
Y-feed motor stopped due to a problem during programming.
Turn off the power, and then check if there are any problems in the Y-feed direction.